Configuring Edge Node; Configuration Procedure - H3C S3610 Series Operation Manual

Operation Manual – RRPP
H3C S3610&S5510 Series Ethernet Switches
[Sysname] rrpp enable

1.5 Configuring Edge Node

1.5.1 Configuration Procedure

Follow these steps to configure edge node:
Enter system view
Create an RRPP domain
and enter its view
Specify a control VLAN for
the RRPP domain
Specify the current device
as the transit node of the
primary ring, and specify
the primary port and the
secondary port
Specify the current device
as the edge node of a
subring, and specify the
common port and the
edge port
Enable the primary ring
Enable the subring
Return to system view
Enable RRPP
To do...
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ]
[ secondary-port interface-type
interface-number ] level
level-value
ring ring-id node-mode edge
[ common-port interface-type
interface-number ] [ edge-port
interface-type interface-number ]
ring ring-id enable
ring ring-id enable
quit
rrpp enable
Use the command...
1-14
Chapter 1 RRPP Configuration
Remarks
—
Required
Required
Required
Required
Required
By default, the
RRPP ring is
disabled.
Required
By default, the
RRPP ring is
disabled.
—
Required
By default, RRPP
is disabled.