Table of Contents
Advertisement
26
en | Mounting Installation
Figure 6.6 Attaching the AutoDome Easy IP to the mounting plate
13. Secure the safety locking screw with the locking torx
wrench (T-10) supplied with the AutoDome Easy IP.
14. Pull excess wire back into the mount tube.
15. Confirm that the housing is electrically grounded.
6.2
Installing the Pipe Mount
1.
Identify a secure hard surface location for the ceiling pipe
mount (supplied separately).
2.
Use the four (4) holes in the flange as a template to mark
the position where the holes should be drilled to secure
the mount.
3.
Drill the four (4) holes in the installation location (screws
not supplied, use a minimum of 10 mm (.39 in.)).
4.
Drill a fifth hole (maximum of 20 mm) in the center of the
four-hole pattern used to mount the flange. Use this hole
to feed the wires through the mount.
5.
Screw the conduit clamp provided into the mounting
flange.
F01U079609 | 1.0 | 2008.08
Installation Manual
AutoDome Easy IP
Bosch Security Systems, Inc.
Advertisement
Table of Contents
