Installing A Pipe Mount And Camera; Tools Required; Installation Requirements; Preparing The Ceiling For Installation - Bosch AUTODOME IP 4000i Installation Manual

AUTODOME IP 4000i
13

Installing a Pipe Mount and Camera

Notice!
Indoor use only!
This mount shall only be installed indoors. No outdoors installation is permitted.
13.1

Tools Required

–
–
–
13.2

Installation Requirements

–
–
13.3

Preparing the Ceiling for Installation

1.
Caution!
Select a rigid mounting location to prevent excessive vibration to the camera.
!
Notice!
The fasteners and mounting surface must be capable of supporting a maximum load of 11.33
kg (25 pounds).
2.
3.
4.
5.
13.4

Installing the Pipe Mount

1.
2.
Ensure that the cables are long enough to reach through the mount and the camera's
mounting cap to the connections from the camera.
1.
2.
3.
Bosch Security Systems
Appropriate tool for cutting a hole in drywall
No. 2 Phillips screwdriver
Torx screwdriver, T-25
The ceiling is thick enough to install the mounting screws.
The ceiling can sustain at least eight (8) times the weight of the camera (1.88 kg (4.14
lb)): > 15 kg (33 lb).
Determine a secure location for the pipe mount. Ensure there is an adequate opening in
the ceiling or mounting structure for the cables to pass through.
Use the direct connect plate as a template to mark the location to drill holes for the four
mounting screws (and anchors (user-supplied) if necessary), and to cut the hole for the
cables.
Drill the holes for the mounting screws.
Drill a hole (maximum of 20 mm [.79 in.]) in the center of the mounting location to feed
the cables through the mount.
Insert the wall anchors (user-supplied), if necessary, into the ceiling at the locations
marked in step 2.
Attach the direct connect plate to the ceiling or mounting surface.
Thread the RJ45 cable and 24 VAC cables through the ceiling and then through the
(adapter).
Attach the mounting flange and (adapter) to the direct connect plate using four M5
screws.
Thread the cables through the pipe mount.
Attach the pipe mount to the mounting flange and (adapter).
Installation Manual
Installing a Pipe Mount and Camera | en
2017.08 | 1.0 | F.01U.xxx.xxx
35