Installing A Pipe Mount (Autodome 4000); Overview; Parts List; Installing The Pipe Mount - Bosch VEZ-400 Series Operation Manual

AUTODOME 4000 Mini PTZ Dome
8

Installing a Pipe Mount (AUTODOME 4000)

8.1

Overview

This chapter details how to mount the AUTODOME 4000 camera to a pipe.
For an outdoor installation, you must obtain the mounting screws with rubber sealing rings
supplied with the camera to ensure a water-tight environment inside the unit and to maintain
an IP Environmental Protection Rating.
Notice!
The image sensors in modern cameras are highly sensitive and require special care for proper
performance and extended lifetime. Follow the guidelines for optimum results with your
camera:
Do not expose to direct sunlight or bright spotlights in operating and non-operating
conditions.
Avoid bright lights in the field of view of the camera. Bright lights cause a "smearing" effect,
which is visible as white lines above and below the highlight. Prolonged exposure to bright
lights may cause bleaching of the sensor's color filters. This will be visible as colored spots in
the picture and is irreversible.
8.2

Parts List

The following table lists the parts included in the Pipe mount (VEZ-A4-PW (white) or VEZ-A4-
PC (charcoal)):
Quantity
1
2
1
1
1
1
1
8.3

Installing the Pipe Mount

Use the following instructions to install a pipe mount.
Note: Certain steps contain additional information for outdoor installations.
Bosch Security Systems, Inc.
Part
Pipe mount: VEZ-A4-PW (white) or VEZ-A4-PC (charcoal)
Pipe mount extension poles, 20 cm (7.9 in.) and 30 cm (11.8 in.)
Pipe extension coupler
Ceiling flange/base
Roll of Teflon tape
Tube of Silicone grease
Installation manual (this booklet)
Operation Manual
Installing a Pipe Mount (AUTODOME 4000) | en 29
2015.08 | |