Table of Contents
Advertisement
AutoDome Easy IP
Problem
Check
The contrast on
Adjust the contrast feature of the monitor.
the screen is
Is the camera exposed to strong light?
weak.
If so, change the camera position and/or adjust the Auto
Exposure settings in the OSD AE menu, or Encoder, Picture
Settings menu in the Settings tab of the web browser menu.
The image on
Does the camera face directly into the sun or fluorescent
the screen is
lighting?
flickering.
If so, reposition the camera and/or adjust the shutter settings
in the Auto Exposure menu in the OSD AE menu.
The image on
Line lock synchronization can only be used if the AC power
the screen is
frequency is 60 Hz for NTSC model cameras and 50 Hz for
distorted.
PAL model cameras. If this is not the case, then change the
synchronization mode to INTernal in the camera's OSD menu.
Forgot
Call Technical Support for assistance.
password or
want to reset it.
Protocol switch
Set your settings as per 7 Setting Protocol and Video Format,
mismatch.
page 33.
Cannot set IP
Check with your IT network administrator that the IP address
address.
is a valid address.
Connected to
Have you installed all the software tools on the PC as per
the camera and
8.2 System Requirements, page 37 and 8.5 Installing the
network but
Required Software, page 39?
cannot see
Does the PC meet the minimum requirements of 8.2 System
video.
Requirements, page 37?
Is the lens iris closed?
Have you added the IP address of the Autodome Easy IP
dome to the list of IP addresses that are "Always Trusted"
in Internet Explorer as per 8.6.3 Using the AutoDome Easy IP
Web Server, page 41?
Bosch Security Systems, Inc.
Installation Manual
Troubleshooting | en 139
F01U079609 | 1.0 | 2008.07
Advertisement
Table of Contents
