Bosch VEZ IP Series Installation Manual page 31

AutoDome Easy IP
Number
1
2
3
4
10. Attach the dome camera to the mounting plate using the
safety wire.
11. Connect all wires to the camera. Ensure that the female
RJ45 connector on the camera's cable assembly is
positioned between the mounting plate and the dome
mounting cap.
Figure 6.5 Attaching the safety wire to the mounting plate
12. Attach the camera to the mounting plate by inserting the
vertical tab into the recessed slot on the top of the camera
dome to the right of the safety locking screw. Rotate the
camera approximately 15 degrees to the right and lock into
place, as shown in the illustration below.
Bosch Security Systems, Inc.
Description
Align "front" of plate here
Feed wires through here
Front of plate
Wall
Installation Manual
Mounting Installation | en
F01U079609 | 1.0 | 2008.08
25