Bosch VEZ IP Series Installation Manual page 50

44 en | Configuring IP Communications
7. If not done (Section 8.6.2 Using the Configuration Tool,
page 41), configure the IP address, subnet mask, and
gateway address provided by your IT department.
8. Click the Set button to save the settings.
9. Close Internet Explorer.
10. Open a new instance of Internet Explorer and type the
original IP address followed by /reset. For AutoDome Easy
IP, use the new IP address to access the Livepage.
For example, type http://192.168.0.1/reset in the
address bar and click Go.
11. Select RUN from the Windows Start menu and type arp -d,
then click OK.
Figure 8.4 Run menu
12. Disconnect the AutoDome Easy IP Ethernet cable from the
dedicated network switch and reconnect the Ethernet
cable to the local area network (LAN).
NOTICE!
Depending on the PC network security settings, the user may
i
have to add the new IP address to the browser's trusted sites
list for the AutoDome Easy IP controls to operate.
F01U079609 | 1.0 | 2008.08 Installation Manual
AutoDome Easy IP
Bosch Security Systems, Inc.