Table of Contents
Advertisement
56
en | Navigating the Menus
10.1.1
Setting and Saving Presets
The AutoDome Easy IP is designed to save up to 60 preset
locations. Each preset location has a pan/tilt/zoom data
capability which is defined by the user (see also 9.4 Entering a
Keyboard Control Command). To set a preset position, proceed
as follows:
1.
Exit the OSD menu.
2.
Move the on-screen joystick to the desired preset position.
3.
Press the Aux Control tab.
4.
Click the next unused preset location number (1-60) then
click the Set Shot button. Note: Preset shots 1-6 can be set
by clicking the Set button followed by one of the buttons
labeled 1-6 in the View Control tab.
The screen displays the message PRESET SAVING...
If the user attempts to overwrite an existing preset shot,
the following confirmation message is displayed:
OVERWRITE CURRENT SCENE?
NOTICE!
If the message OUT OF SEQUENCE is displayed, a preset save is
being attempted that is not available. All preset positions must
i
be set in sequential order. To verify the next number in the
sequence, enter the Preset menu and scroll through the saved
presets. The last number without an asterisk displayed is the
next available preset position.
10.1.2
Recalling a Preset Position
The AutoDome Easy IP is designed to recall up to 60 preset
locations.
To recall a preset position, proceed as follows:
1.
Press the Aux Control tab.
2.
Press the desired screen shot # (1-60) + Show Shot. The
AutoDome Easy IP displays the preset position with the
user-defined title in the upper left-hand corner. If the user
attempts to recall a shot that has not been preset, the
following error message is displayed: DATA NOT
PROGRAMMED
F01U079609 | 1.0 | 2008.08
Installation Manual
AutoDome Easy IP
Bosch Security Systems, Inc.
Advertisement
Table of Contents
