Bosch VEZ IP Series Installation Manual page 137

AutoDome Easy IP
Uploading the wrong files can result in the unit no longer being
addressable, in which case you must replace the device. Do not
interrupt the firmware installation for any reason. An
interruption can result in incorrect programming of the Flash
EPROM; which can result in the unit no longer being
addressable and you must replace the device.
To update a new version of the firmware, do the following:
1. Save the updated file to your hard drive.
2. Type the fully-qualified path to the file in the Firmware
field. If you do not know the path, click Search and
navigate to the update file.
3. Click Upload to begin transferring the file to the device.
The system opens the AutoDome Easy IP Firmware Upload
window that lists applicable updates. The system loads the
updates automatically.
4. Click Upload Firmware.
5. The installation program unpacks the firmware and
updates the Flash EPROM memory. The unit restarts
automatically once the upload has successfully completed.
6. If the Connect LED lights up red, the upload has failed and
must be repeated. To perform the upload you must now
switch to a special page. In the address bar of your
browser, type /main.htm after the IP address of the
AutoDome (for example 192.168.0.10/main.htm).
7. Repeat the upload.
Configuration Upload
To upload a new configuration file, do the following:
1. Save the updated file to your hard drive.
2. Type the fully-qualified path to the configuration file in the
Configuration field. If you do not know the path, click
Search and navigate to the file.
3. Ensure that the configuration file is from the same type of
device that you want to reconfigure.
4. Click Upload to begin transferring the file to the device.
Bosch Security Systems, Inc. Installation Manual
Settings Menus | en 131
F01U079609 | 1.0 | 2008.08