Installing A Pipe Mount And Camera; Preparing The Ceiling For Installation; Installing The Pipe Mount - Bosch AUTODOME IP starlight 5100i IR Installation Manual

AUTODOME IP starlight 5100i IR
11

Installing a Pipe Mount and Camera

11.1

Preparing the Ceiling for Installation

1.
Caution!
Select a rigid mounting location to prevent excessive vibration to the camera.
!
Notice!
i
The fasteners and mounting surface must be capable of supporting a maximum load of 11.33
kg (25 pounds).
2.
3.
4.
5.
11.2

Installing the Pipe Mount

Ensure that the cables are long enough to reach through the mount and the camera's
mounting cap to the connections from the camera.
1.
2.
3.
4.
5.
6.
Bosch Security Systems
Determine a secure location for the pipe mount. Ensure there is an adequate opening in
the ceiling or mounting structure for the cables to pass through.
Use the direct connect plate as a template to mark the location to drill holes for the four
mounting screws (and anchors (user-supplied) if necessary), and to cut the hole for the
cables.
Drill the holes for the mounting screws.
Drill a hole (maximum of 20 mm [.79 in.]) in the center of the mounting location to feed
the cables through the mount.
Insert the wall anchors (user-supplied), if necessary, into the ceiling at the locations
marked in step 2.
Attach the mounting flange and (adapter) to the direct connect plate using four M5
screws.
Thread the cables through the pipe mount.
Attach the pipe mount to the mounting flange and (adapter).
If you choose to install the pipe mount extension, thread the cables through the
extension. Attach the pipe extension to the open end of the pipe mount.
Attach the hook at the end of the Safety Tether to the loop attached to the top of the
camera.
Connect the mating connectors from the user-supplied cables from the pipe to the
matching connectors from the camera. Refer to the chapter Connection for more
information.
Installation Manual
Installing a Pipe Mount and Camera | en 39
2021-02-19 | 0.7 |