Table of Contents
Advertisement
2
en | Safety
the unit from lightning and power line surges.
7.
Control adjustment - Adjust only those controls specified
in the operating instructions. Improper adjustment of
other controls may cause damage to the unit. Use of
controls or adjustments, or performance of procedures
other than those specified, may result in hazardous
radiation exposure.
8.
Overloading - Do not overload outlets and extension cords.
This can cause fire or electrical shock.
9.
Power cord and plug protection - Protect the plug and
power cord from foot traffic and from being pinched by
items placed upon or against them at electrical outlets;
also protect the power cord's exit from the unit. For units
intended to operate with 230 VAC, 50 Hz, the input and
output power cord must comply with the latest versions of
IEC Publication 227 or IEC Publication 245.
10. Power disconnect - Units with or without ON/OFF
switches have power supplied whenever the power cord is
inserted into the power source; however, the unit is
operational only when the ON/OFF switch is in the ON
position. The power cord is the main power disconnect
device for switching off the voltage for all units.
11. Power sources - Operate the unit only via the type of
power source indicated on the label. Before proceeding,
be sure to disconnect the power from the cable being
connected to the unit.
–
For battery powered units, refer to the operating
instructions.
–
For units supplied by an external power source, use
only the recommended or approved power supplies.
–
For limited power source units, this power source
must comply with EN60950. Substitutions may
damage the unit or cause fire or shock.
–
For 24 VAC units, voltage applied to the unit's power
input should not exceed ±10% or 26.4 VAC. User-
supplied wiring must comply with local electrical
codes (Class 2 power levels). Do not ground the
F01U079609 | 1.0 | 2008.08
Installation Manual
AutoDome Easy IP
Bosch Security Systems, Inc.
Advertisement
Table of Contents
