Table of Contents
Advertisement
66
en | Navigating the Menus
10.5.1
Configuring the Alarm for IP Alarm Features
The AutoDome Easy IP alarm configuration must be set in two
(2) separate locations. To configure an alarm, proceed as
follows:
1.
Press the Aux Control tab then press 4 + 6 + Aux On via the
on-screen keypad to access the main menu.
2.
To navigate throughout the on-screen menu, press the
View Control tab to access the on-screen joystick.
3.
Press the down arrow on the on-screen joystick with your
mouse, select ALARM, then press the right arrow to display
the menu options.
4.
When satisfied with your selections, press the down arrow
to select SAVE AND EXIT.
To exit without saving, select EXIT W/O SAVE.
5.
Exit the main menu.
6.
Press the Settings link within the AutoDome Easy IP web
interface, click the Alarm drop-down list, then press Alarm
Sources.
7.
Click the Alarm Input 1 drop-down list and make the same
selection (for example: NO or NC) as you made above, then
press Set.
Figure 10.1 Alarm Sources dialog box
10.5.2
Releasing an Alarm
When releasing an alarm, there are two (2) modes of operation.
Time out releases the alarm after the dwell time. However, time
F01U079609 | 1.0 | 2008.08
Installation Manual
AutoDome Easy IP
Bosch Security Systems, Inc.
Advertisement
Table of Contents
