Table of Contents
Advertisement
AUTODOME IP starlight 7000 HD
10. Thread the Dome Cap onto the down pipe and tighten securely. See the illustration
Warning!
You must thread the Dome Cap onto the Down Pipe until it is tight. Failure to do so can result
!
in damage, serious injury, or death.
Figure 8.23: Attach Dome Cap
1
2
11. Run a bead of RTV Silicon sealant around the down pipe/Dome Cap interface to seal any
12. Proceed to Wire the Pipe Interface Board, page 49.
Notice!
Use a guy-wire to aid in stabilizing the Parapet Arm. Replace the 1/4 inch cap screw with a
threaded 1/4-inch stainless steel eye bolt (not supplied). Loop the guy-wire through the eye
bolt and attach both ends to anchor spots on the roof.
8.5
Installing the VG4-A-9543 Pipe Mount
This section details the installation steps for the VG4-A-9543 Pipe Mount. If you are installing
the Roof Parapet mount, refer to Installing the VGA-ROOF-MOUNT, page 45 for instructions.
Notice!
Customer must supply 1-1/2 inch (NPS) pipe threaded on both ends with a minimum length
of 5 inches (12.7 cm).
You must use Teflon tape for thread-sealing compound.
All screws shall be tightened securely.
Bosch Security Systems
below.
Thread Sealant or tape
Dome Cap
gaps between the down pipe and the Dome Cap.
Installing the Roof Parapet and Pipe Mounts | en
Operation Manual
47
2016-07 | 1.0 | F.01U.283.679
Hide quick links:
Advertisement
Table of Contents
