Table of Contents
Advertisement
34
en | Setting Protocol and Video Format
7
Setting Protocol and Video Format
The settings of DIP Switch S501 are factory set and should not
be adjusted. However, if the camera is operating incorrectly,
the proper configuration follows:
Switch 8 - set to match the video standard of the camera
model; NTSC (60 Hz) ON
– or –
PAL (50 Hz) OFF. Switches 9 and 0 - set to Bosch protocol.
NOTICE!
The error message: PROTOCOL IS NOT MATCHED is displayed
i
during the power-up cycle if switches 9 and 0 are not set
correctly.
Figure 7.1 AutoDome Easy camera function and protocol selection
switches
Reference #
1
2
S/W no.
8
Table 7.1 Dome camera function
No. 9
ON
Table 7.2 Dome camera protocol function
F01U079609 | 1.0 | 2008.08
Description
Dome camera function
Dome camera protocol function
ON
OFF
NTSC
PAL
No. 0
Protocol
OFF
Bosch
Installation Manual
AutoDome Easy IP
Function
NTSC/PAL
Bosch Security Systems, Inc.
Advertisement
Table of Contents
