Table of Contents
Advertisement
112 en | Settings Menus
6.
Click OK to close the window.
12.6.2
Creating A Partition
The AutoDome Easy IP allows the user to create a partition (see
also 12.6 Partitioning) by doing the following:
1.
Open the AutoDome Easy IP Livepage, then click the
Settings link.
2.
Click the Recording drop-down list, then click Partitioning.
The Partitioning window is displayed.
3.
Click the Create partition button to start the wizard for
creating partitions.
4.
Enter the required information using the available controls.
5.
Click Next to continue, Back to view the previous step,
Cancel to discontinue the process, and Finish to save the
changes and exit the wizard.
12.6.3
Editing a Partition
The Edit partition window provides an overview of the current
partition configuration, which can be modified at any time. All
modifications result in the reorganization of the partition and all
sequences stored are lost. It is recommended to back up all
important sequences before modifying the partition.
The unit uses a special recording mode during alarm recording
for optimal usage of storage capacity: as soon as a time gap for
alarm recording begins, a recording is continuously made on
one segment, which is the size of a complete alarm sequence
(pre- and post-alarm time). This segment in the partition
functions in a similar manner to a ring buffer and is overwritten
until an alarm is actually triggered. Recording occurs on the
segment only for the duration of the preset post-alarm time and
a new segment is subsequently used in the same manner.
To edit a partition, do the following:
1.
Open the AutoDome Easy IP Livepage, then click the
Settings link.
2.
Click the Recording drop-down list, then click Partitioning.
The Partitioning window is displayed.
F01U079609 | 1.0 | 2008.08
Installation Manual
AutoDome Easy IP
Bosch Security Systems, Inc.
Advertisement
Table of Contents
