Table of Contents
Advertisement
90
en | Settings Menus
(Europe: DD.MM.YYYY; USA: MM.DD.YYYY; Japan: YYYY/MM/
DD).
Unit Date and Time
If there are a number of devices operating in your system or
network, it is important to synchronize their internal clocks. For
example, it is only possible to carry out correct identification
and evaluation of recordings occurring at the same time if all
devices are operating on the same time.
To set the Date/Time, do the following:
1.
Open the AutoDome Easy IP Livepage, then click the
Settings link followed by the General drop-down menu,
then click Date/Time. The Date/Time screen is displayed.
2.
Click the Date format drop-down menu to select the
desired date format.
3.
Enter the current date within the Unit date fields. Since the
unit time is controlled by the internal clock, it is not
necessary to enter the day of the week. This is added
automatically.
4.
Enter the current time within the Unit time fields or click
the Synchr. PC button to apply the system time from your
computer to the camera, then click the Set button.
Figure 12.8
12.1.6
Time Server Menu
The AutoDome Easy IP camera can receive the time signal from
a time server using the time server protocol (RFC 868) and then
use it to set the internal clock. The device calls up the time
signal automatically every ten (10) minutes.
F01U079609 | 1.0 | 2008.08
Date/Time Menu
Installation Manual
AutoDome Easy IP
Bosch Security Systems, Inc.
Advertisement
Table of Contents
