KVH Industries LTD9116MKIT User Manual page 68

Chapter 3: Operating the system
Holding a call
During a call, you may place the initial call on hold while another call is made.
Different types of phone have different methods/keys for the
Note
functions listed below. If you have another type of phone than the
ones listed below, refer to the documentation for your
phone/handset.
TracPhone FleetBroadband IP Handset:
Select Options > Hold in the IP handset. For further details, refer to the section
"Handling calls" in the user manual for the TracPhone FleetBroadband IP
Handset.
Analogue 2-wire phones with R key:
If you want to:
Place a call on hold.
Place the existing call on
hold and establish a new call.
Shuttle between the two
calls.
Clear the held call, if no
waiting call exists.
Clear an active call and
return to the held call.
56
Do as follows (standard 2-wire phone):
Press R 2 #.
Press R and dial the second phone number
followed by #.
Press R 2 #
(irrespective of whether the second call was
acquired using Call Hold or acceptance of
Call Waiting.)
Press R 0 #.
Press R 1 #.
Note that this is only possible if no waiting
call exists.
Using a phone or fax machine