Table of Contents
Advertisement
2. Click Add.
3. Enter the values for your device.
•
Destination: The IP address you want to route to.
•
Netmask: The netmask you want to route to.
•
Gateway: The gateway, e.g. the address of a wireless access point or
router to which the destination device is connected.
4. Click Apply.
The values for the new entry are now in the list. This means that the
terminal can communicate with the destination IP address on the other
side of the gateway.
Chapter 4: Using the web interface
Setting up the interfaces
111
Advertisement
Table of Contents
Troubleshooting
