Chapter 4: Using the web interface
You can also set up the local IP address used by the connected devices to
access the terminal. The drawing below shows the default setup.
Device 1
Device 2
To change the local IP addresses, do as follows:
1. From the left navigation pane, select SETTINGS > LAN.
2. At DHCP status, select Enabled (recommended for most purposes), or
Disabled.
106
Local IP addresses
(default setup)
assigned by the
terminal (DHCP)
assigned by the
terminal (DHCP)
Setting up the interfaces
192.168 .0.1
Terminal
192.168 .0.1