KVH Industries LTD9116MKIT User Manual page 148

Chapter 4: Using the web interface
Configuring the I/O interface
To configure the I/O pins, do as follows:
1. Select SETTINGS > Discrete I/O.
2. For each pin you want to use, select Enabled.
3. For each pin, select the function of the pin. Refer to the previous section,
I/O pins and their functions on page 133.
4. If you are using the Ignition function and you want the terminal to stay on
for a few minutes after the Ignition is switched off, enter the number of
minutes under DELAYED SHUTDOWN.
For further information on the Ignition function, see Using the ignition
system on page 22.
5. If you are using a ringer output, select the incoming call types that should
activate the ringer under RINGER OUTPUT.
136 Setting up the interfaces