KVH Industries LTD9116MKIT User Manual page 127

3. Set the call type(s) for incoming calls.
You can select Standard, 3.1 kHz Audio, UDI and/or RDI. Note that
TracPhone FB250 only supports Standard or 3.1 kHz Audio.
Connected devices will only receive incoming calls with the call
Note
types that are selected here.
For example, if only Standard is selected, and a G4 fax call
(using call type UDI) arrives, a fax connected to the ISDN port
will not receive the incoming call.
4. Set the MSN (Multiple Subscriber Number) numbers that are to be
assigned to each call type.
Note that this setting only applies to the call type selected above the MSN
number, and only if the connected device supports the call type used.
If you have assigned a number to the ISDN port, the MSN setting is not
available.
If you set an MSN number to anything other than <None>,
Important
connected devices must be programmed with these MSN
numbers.
You have the following options with the MSN numbers:
• <None>. No MSN numbers are used. An incoming call is accepted in all
devices connected to this port.
• 1*, 2*, 3* or 4*: If, for example, you select 1* at Standard call type, an
incoming Standard call is accepted by all devices that are programmed
with the number 1* and connected to the ISDN interface.
• 0401, 0402: These are local numbers for separate devices connected to
the ISDN interface.
An incoming call is accepted by devices that are programmed with the
selected number and connected to the ISDN interface.
You can combine the MSN settings.
Chapter 4: Using the web interface
Setting up the interfaces 115