T&B&S + 980Mm Band Feed - Epson Stylus Pro 7400 Service Manual

EPSON Stylus Pro 7400/7800/9400/9800
5.3.5 T&B&S + 980mm Band Feed
Paper feeding amount and the left, right, top and bottom margins can be adjusted using
this menu.
Paper Used
Size: 24" (Stylus Pro 7400/7800)
44" (Stylus Pro 9400/9800)
Type: Doubleweight Matte Paper
Specifications
Top margin: 10 ± 5 mm
Bottom margin: 14 ± 5 mm
Side margin: 10 ± 5 mm
980mm feed: 980mm ± 10 mm
Procedure
1. Start up the Adjustment Program and select [T&B&S + 980mm Band Feed].
2. Click the [Print] button to print the adjustment pattern.
3. Referring to Figure 5-29, measure the distance of the following four points.
Top margin
Bottom margin
Side margin
Band-feed amount
4. Enter the values measured in
words inside the parentheses indicate the names displayed on the screen.)
Top margin (Top Margin)
Bottom margin (Bottom Margin)
Side margin (Side Margin Adjust)
Band-feed amount (980mm Feed)
5. Click the [Write] button and then click the [Print] button to print the
adjustment pattern again.
6. Perform Step 3 and Step 4 and click the [Write] button.
7. After confirming that the all values are within the specified range, click the
[Finish] button.
If they are not, perform Step 3
Adjustment
Step 3 into the corresponding edit boxes. (The
to Step 5 again.
Be sure to place the adjustment pattern print on a flat surface when
C A U T I O N
performing the measurement.
Figure 5-28. T&B&S (Roll Paper) + 980mm Band Feed Screen
Basic Adjustment
Revision B
318