Epson Stylus Pro 7400 Service Manual page 235

EPSON Stylus Pro 7400/7800/9400/9800
4.2.4.3 INLETS ASSY.
When removing the INLET ASSY., do not start the work
W A R N I N G
immediately after disconnecting the AC cable. Wait for at least five
minutes for the electrolytic capacitor to finish discharging residual
charges.
1. Remove the Rear Cover. See Section 4.2.3.6 on page 225.
2. Remove the screw that secures the grounding wire.
One C.C.S. M4 x 8 screw
3. Disconnect the connector of the INLET ASSY. from the P/S BOARD ASSY., and
release the INLET ASSY harness and the grounding wire from the retaining clip.
4. Remove the screw that secures the INLET ASSY.
One C.C.S. M4 x 8 screw
5. Slide the INLET ASSY leftwards to release its right bottom tab from the notch,
and remove the INLET ASSY.
Disassembly & Assembly
Connector
P/S BOARD ASSY.
Disassembly Procedure
2: C.C.S. 4x8
Retaining Clip
Grounding
4: C.C.S. 4x8
Wire
Figure 4-42. Removing the INLET ASSY.
Revision B
INLET ASSY.
5
Tab
235