Epson Stylus Pro 7400 Service Manual page 263

EPSON Stylus Pro 7400/7800/9400/9800
4.2.6.7 IM (Ink Mark) Sensor
1. Remove the L SIDE COVER ASSY.
2. Unlock the CARRIAGE ASSY. and move the unit to the center.
4.2.1.2 on page 215.
3. Release the FFC and harnesses from the retaining clip on the IM SENSOR
COVER. See Figure 4-96.
4. Remove the screw that secures the IM SENSOR HOLDER.
One C.P.S.(S-P2) M3 x 5 screw
When reinstalling the IM Sensor Holder, make sure the two guide
pins on the Holder are set in the positioning holes.
5. Move the CARRIAGE ASSY. to the left while holding the IM Sensor Holder with
your fingers so that it does not touch the Platen.
6. Pull the IM Sensor Holder out through the hole on the bracket.
7. Remove the screw that secures the IM Sensor Holder and remove it.
4-97.
One C.B.P. M3 x 6 screw
When reinstalling the IM Sensor Holder, make sure the positioning
tab of the Holder is set in the positioning slot on the IM SENSOR
COVER. See Figure 4-97.
Disassembly & Assembly
See Section 4.2.3.5 on page 224.
See Section
See Figure 4-96.
See Figure 4-96.
See Figure 4-97.
See Figure
Disassembly Procedure
C.P.S.(S-P2) M3x5
FFC
Retaining
Clip
Guide Pins
IM Sensor Holder
Figure 4-96. Screw Securing the IM Sensor Holder
IM SENSOR COVER
C.B.P. M3x6
Positioning Tab
Figure 4-97. Removing the IM Sensor Holder
Revision B
Harnesses
Hole
6
263