Epson Stylus Pro 7400 Service Manual page 186

EPSON Stylus Pro 7400/7800/9400/9800
COVER OPEN
CLOSE COVER
Description
The front cover is open.
The front cover is open.
LEVER RELEASED
LOAD PAPER
Description
The paper set lever is released.
The Paper Set Lever is released.
Troubleshooting
Remedy
Close the front cover.
If the cover is opened while the printer is
performing a flushing operation before
feeding paper, it stops the flushing
operation and resumes the flushing and
feeding the paper after the cover is closed.
If the cover is opened while the printer is
performing the paper feeding operation,
the printer stops after feeding the paper to
the starting position. When the cover is
closed, it starts to detect paper width and
enters into ready mode.
When the cover is opened while the printer
is ejecting the paper, the printer causes
PAPER EJECT ERROR (p.181).
If the cover is opened while the printer is
cutting paper, the printer causes PAPER
CUT ERROR (p.183).
When the cover is opened while turning
the power OFF, the printer turns OFF after
placing the cap on the printhead.
Remedy
Lower the Paper Set Lever.
Troubleshooting based on Panel Messages
LEVER RELEASED
LOWER THE PAPER SET LEVER
Description
The paper set lever is released during
printing.
The Paper Set Lever is released while the
printer is performing any of the following
operations.
1. Turning the power ON or OFF, or cleaning 1. Place the Paper Set Lever to its front
2. Feeding paper, printing or ejecting paper
3. During paper cutting operation
Revision B
Remedy
position.
2. If you interrupt the paper feeding operation
by placing the Paper Set Lever to its front
position, the printer performs paper set
sequence and the paper type is
automatically determined by the paper
detection sensors (The P Rear Sensor and
the P EDGE Sensor). During the paper set
sequence, the printer enters into a wait
state for paper setting initializing trigger.
Pressing the [Pause] button backs the
printer to the paper set sequence operation.
(If you remove the paper without canceling
the job (resetting the panel) and lower the
Paper Set Lever, PAPER OUT (p.181)
error will occur after the printer recovers
from the LEVER RELEASED error.) If the
P EDGE Sensor is ON with the Paper Set
Lever lowered, the printer detects the
condition during the paper set sequence
and judges that the paper is fed from the
front side. This causes a paper jam as the
printer then tries to back-feed the paper
and a paper jam error message will be
displayed on the panel. If this happens,
release the Paper Set Lever to remove the
paper and back the lever to its front
position.
3. Cancel the cutting operation and remove
the paper, then back the Paper Set Lever to
its front position.
186