Epson Stylus Pro 7400 Service Manual page 270

EPSON Stylus Pro 7400/7800/9400/9800
10. Remove the three screws that secure the PRINT HEAD and remove it.
4-109.
Three C.B.P. M2.6 x 6 screws
When removing the PRINT HEAD, the ABSORBER, CR may
come off the HOLDER, HEAD. If this occurs, attach the
ABSORBER, CR as shown in the figure below.
Figure 4-108. Reinstalling the ABSORBER, CRs
11. Peel off the two Head FFCs secured to the PRINT HEAD with two-sided tape, and
then disconnect the FFCs from the PRINT HEAD.
Whenever the PRINT HEAD is reinstalled or replaced, the
A D J U S T M E N T
R E Q U I R E D
corresponding adjustment must be carried out.
page 292. When replacing the PRINT HEAD with a new one, note
down the 40-digit Head Rank ID indicated on the ID label affixed to
the new PRINT HEAD.
Disassembly & Assembly
See Figure
ABSORBER, CRs
See Figure 4-110.
See Chapter 5 on
See Figure 4-109.
C.B.P. M2.6x6
Figure 4-109. Screws Securing the PRINT HEAD
Disassembly Procedure
Head Rank ID Label
Head FFC
Figure 4-110. Disconnecting the Head FFC
Revision B
PRINT HEAD
Two-sided
Tape
270