Epson Stylus Pro 7400 Service Manual page 265

EPSON Stylus Pro 7400/7800/9400/9800
4.2.6.8 P Edge Sensor
1. Disconnect the connector of the P Edge Sensor from the BOARD ASSY., SUB.
See Section 4.2.4.4 on page 236.
2. Pull out the harness of the P Edge Sensor through the notch of the CR BOARD
HOLDER, and release the harness from the retaining
3. Remove the CUTTER HOLDER ASSY.
4. Remove the screw that secures the Edge Sensor Holder and remove it.
4-101.
One C.C.P. M3 x 8 screw
Set the two guide pins of the Edge Sensor Holder in the positioning
holes. See Figure 4-101.
Disassembly & Assembly
clip.See Figure 4-100.
See Section 4.2.5.6 on page 248.
See Figure
Disassembly Procedure
P Edge Sensor
harness
CR BOARD HOLDER
Notch
Figure 4-100. Releasing the P Edge Sensor Harness
Guide Pins
Edge Sensor Holder
Figure 4-101. Removing the Edge Sensor Holder
Revision B
Retaining Clip
C.C.P. 3x8
265