Epson Stylus Pro 7400 Service Manual page 218

EPSON Stylus Pro 7400/7800/9400/9800
4.2.2.3 Cutter
1. After turning the printer ON, press and hold the Paper Source button
seconds or more to put the printer into the cutter replacement mode.
2. The CARRIAGE ASSY. will move to the cutter replacement position.
3. Open the FRONT COVER ASSY.
Beware of the following items when performing the next step.
C A U T I O N
Push the boss on the Cutter lightly. Do not push it too much as
the blade edge may damage the printer's internal components.
The Cutter may pop up if you push the Cutter too much and
release it suddenly as a spring is incorporated into the Cutter.
Be careful not to do that.
Be careful not to drop the Cutter or hit it against hard object
such as metal parts, or the cutter blade may chip.
4. Press down the boss on the Cutter lightly and turn the Cutter Cap clockwise.
Figure 4-10.
5. Remove the Cutter from the CARRIAGE ASSY.
Disassembly & Assembly
for 3
See
See Figure 4-11.
Disassembly Procedure
4-1
Figure 4-10. Removing the Cutter (1)
Cutter
Figure 4-11. Removing the Cutter (2)
Revision B
Cutter Cap
4-2
218