EPSON Stylus Pro 7400/7800/9400/9800
4.2.5.6 CUTTER SOLENOID ASSY.
1.
Disconnect the connector of the CUTTER SOLENOID ASSY. from the BOARD
ASSY, SUB.
See Section 4.2.4.4 on page 236.
2.
Pull out the harness of the CUTTER SOLENOID ASSY. through the notch of the
CR BOARD HOLDER.
See Figure 4-67.
3.
Remove the CR ENCODER HOLDER.
4.
Cut the TILAP and release the harness, FFC, and the grounding wire.
4-68.
Secure the following harnesses, FFCs, and the grounding wire with
a TILAP at the position shown in the figure.
CUTTER SOLENOID ASSY. harness
P Edge Sensor harness
CR Encoder Sensor FFC
IM Sensor FFC
Grounding wire (connected between the BOARD ASSY, SUB
and the CARRIAGE ASSY.)
5.
Remove the three screws that secure the CUTTER HOLDER ASSY. and remove
it.
See Figure 4-68.
Three C.P.S.(S-P2) M3 x 5 screws
Set the two positioning holes of the CUTTER HOLDER ASSY. onto
the two guide pins.
See Figure 4-68.
Disassembly & Assembly
See Section 4.2.5.5 on page 246.
See Figure
See Figure 4-68.
Disassembly Procedure
CUTTER SOLENOID
ASSY. harness
CR BOARD HOLDER
Notch
Figure 4-67. Pulling Out the CUTTER SOLENOID ASSY. Harness
Guide Pin
C.P.S.(S-P2) 3x5
Figure 4-68. Removing the CUTTER HOLDER ASSY.
Revision B
TILAP
Guide Pin
CUTTER HOLDER ASSY.
248