Epson Stylus Pro 7400 Service Manual page 223

EPSON Stylus Pro 7400/7800/9400/9800
4.2.3.4 R SIDE COVER ASSY.
Ink may leak from the Cleaning Unit while or after removing the R
C A U T I O N
SIDE COVER ASSY. Have a waste cloth beforehand to wipe out
the leaked ink. When the R SIDE COVER ASSY. must be removed
for many hours, set the Maintenance Tank to collect ink leaked
from the Cleaning Unit.
1. Remove the PANEL ASSY. See Section 4.2.3.1 on page 220.
2. Remove the Maintenance Tank.
3. Remove the Spindle. See Section 4.2.2.4 on page 219.
4. Remove the H Top Cover Assy.
5. Remove the I/H COVER R ASSY.
6. Move the PRESSURE LEVER KNOB to its rear end position, and remove the
screw that secures the knob.
One C.B.P. (P1) M4 x 12 screw
7. Move the PRESSURE LEVER KNOB to its front end position and remove it.
8. Move the PRESSURE LEVER to its rear end position.
9. Remove the Side Cover Screw Cap.
Never forget to reattach the Side Cover Screw Cap, or the printer
C A U T I O N
may malfunction due to noise occurred in the internal electric
circuits. The caps are necessary to prevent the noise.
10. Remove the eight screws that secure the R SIDE COVER ASSY. and remove it.
Three C.B.P. M4 x 12 screws
One C.F.P. M4 x 12 screw
Four C.C.S. M4 x 8 screws
Make sure that there is no gap between the R SIDE COVER ASSY.
and the frame, then screw the R SIDE COVER ASSY.
Disassembly & Assembly
See Section 4.2.2.2 on page 217.
See Section 4.2.3.2 on page 221.
See Section on page 222.
10: C.F.P. 4x12
10: C.B.P. 4x12
10: C.B.P. 4x12
Figure 4-22. Removing the R SIDE COVER ASSY.
Disassembly Procedure
Revision B
PRESSURE LEVER
PRESSURE LEVER
KNOB
6
6: C.B.P.(P1) 4x12
R SIDE COVER ASSY.
10
9
Side Cover
Screw Cap 10: C.C.S. 4x8
8
223