Epson Stylus Pro 7400 Service Manual page 276

EPSON Stylus Pro 7400/7800/9400/9800
8. Release the harness of the I/C LEVER SENSOR R from the three hooked tabs of
the HARNESS/TUBE STOPPER and pull out the harness.
9. Pull out the TUBE, PRESSURIZING from the HOLDER ASSY., IC, RIGHT, and
release it from the three retaining clips of the HARNESS/TUBE STOPPER.
Make sure that the joint of the TUBE, PRESSURIZING is
located at the retaining clip as shown in the figure below.
Figure 4-120. Routing the TUBE, PRESSURIZING
Insert the TUBE, PRESSURIZING all the way.
Disassembly & Assembly
HARNESS/TUBE STOPPER
Retaining clip Figure 4-121. Releasing the I/C LEVER SENSOR R Harness and the TUBE,
Joint
Disassembly Procedure
8: Hooked tabs
I/C LEVER SENSOR
R Harness
9: Hooked tabs
TUBE,
PRESSURIZING
8: Hooked tabs
PRESSURIZING
Revision B
276