Epson Stylus Pro 7400 Service Manual page 261

EPSON Stylus Pro 7400/7800/9400/9800
4.2.6.5 P Thick1 Sensor, P Thick2 Sensor
1. Remove the H TOP COVER ASSY.
2. Remove the screw that secures the P Thick Sensor Mounting Plate and remove it.
See Figure 4-93.
One C.C.S. M3 x 8 screw
When reinstalling the P Thick Sensor Mounting Plate, make sure
the two guide pins on the Mounting Plate are set in the mounting
holes. See Figure 4-93.
3. Release the three tabs that secure each of the P Thick1 Sensor and the P Thick2
Sensor and remove the two Sensors.
4. Remove the connector both from the P Thick1 Sensor and the P Thick2 Sensor.
See Figure 4-94.
Whenever either or both of the P Thick1 Sensor and the P Thick2
A D J U S T M E N T
R E Q U I R E D
Sensor is/are reinstalled or replaced, the corresponding adjustment
must be carried out. See Chapter 5 on page 292.
Disassembly & Assembly
See Section 4.2.3.2 on page 221.
See Figure 4-94.
Disassembly Procedure
P Thick Sensor Mounting Plate
C.C.S. M3x8
Guide Pins
Figure 4-93. Screws Securing the P Thick Sensor Mounting Plate
3-1
3-1
3-1
3-1
3-1
3-1
3-2
4
P Thick2 Sensor
P Thick1 Sensor
Figure 4-94. Removing the P Thick1 Sensor and P Thick2 Sensor
Revision B
Upper Right of the Printer
3-2
4
261