Epson Stylus Pro 7400 Service Manual page 187

EPSON Stylus Pro 7400/7800/9400/9800
PAPER JAM
REMOVE PAPER
Description
A paper jam occurred.
A paper jam occurred.
INK CARTRIDGE
INSTALL INK CARTRIDGE
Description
The ink lever is released and no cartridge
is installed yet.
The Ink Lever is released, and no ink
cartridge is installed.
NO MAINTENANCE TANK
INSTALL THE (LEFT (RIGHT) SIDE) MAINTENANCE TANK
Description
The Maintenance Tank is not installed on
the printer.
The Maintenance Tank is not installed on the
printer.
Troubleshooting
Remedy
Release the Paper Set Lever, open the front
cover and remove the jammed paper.
Close the front cover and turn the printer
OFF. Leave the printer for a while and then
turn it ON.
Remedy
Install the ink cartridge (new one) indicated
on the LCD panel and lower the Ink Lever.
Remedy
Install the Maintenance Tank.
Troubleshooting based on Panel Messages
F/W INSTALL ERROR
UPDATE FAILED
RESTART THE PRINTER
Description
The printer failed to update the firmware.
The printer failed to update the firmware.
I/F CARD ERROR
CHECK CARD TYPE
Description
A type B optional interface error
An unsupported interface card is installed.
PRINTER ERROR
RESTART THE PRINTER
Description
Rebooting the printer is required.
Rebooting the printer is required during
recovering form an error.
CARRIAGE LOCKED
RELEASE THE CARRIAGE LOCK
Description
The Carriage is locked.
The clamping plate for transportation has not
been removed yet.
Revision B
Remedy
Turn the printer OFF and wait for a while to
turn it back ON. Then retry updating the
firmware.
Remedy
Turn the printer OFF and remove the Type-B
interface. Then turn the printer ON.
Remedy
Turn the printer OFF and turn it back ON
after leaving it for a while.
Remedy
Remove the clamping plate.
187