Epson Stylus Pro 7400 Service Manual page 254

EPSON Stylus Pro 7400/7800/9400/9800
9. Remove the four screws that secure each of the three VACUUM FAN Assies.
Figure 4-79.
12 (4 pcs. x 3) C.C.S. M3 x 8 screws
10. To remove the left and right VACUUM FAN Assies, pull them toward you and
then downward as far as they go to pull out their rear, and raise the rear toward you
without raising the front to remove them from the rear.
11. Pull the right VACUUM FAN ASSY. downward and pull out its rear toward you.
See Figure 4-81.
12. Turn the FRONT COVER, HINGE, R toward the inner side to release the right
side of the right VACUUM FAN ASSY., and then raise the rear of the assy.
toward you to remove it from the rear.
The Stylus Pro 7400/7800 have two VACUUM FAN Assies.
C H E C K
P O I N T
VACUUM FAN ASSY.
C.C.S. 3x8
Figure 4-79. Screws Securing the VACUUM FAN ASSY.
Disassembly & Assembly
See Figure 4-80.
See Figure 4-81.
Disassembly Procedure
See
Figure 4-80. Removing the Left and Center VACUUM FAN Assies
Figure 4-81. Removing the Right VACUUM FAN ASSY.
10-2
10-1
12-1
11-2
11-1
Revision B
12-2
FRONT COVER,
HINGE, R
254