Epson Stylus Pro 7400 Service Manual page 249

EPSON Stylus Pro 7400/7800/9400/9800
6. Release the harness of the CUTTER SOLENOID ASSY. from the retaining clip
and the hooked tab of the IM Sensor Cover.
7. Remove the three screws that secure the CUTTER HOLDER.
Three C.C.P. M3 x 8 screws
8. Pull out the harness of the CUTTER SOLENOID ASSY. through the notch of the
CUTTER HOLDER BRACKET, and remove the CUTTER HOLDER.
4-70.
Set the tab and hooked tab of the CUTTER HOLDER into the
slots of the frame.
Route the harness of the CUTTER SOLENOID ASSY. through
the notch of the hooked tab on the CUTTER HOLDER.
Figure 4-69. Reinstalling the CUTTER HOLDER
9. Remove the Cutter. See Section 4.2.2.3 on page 218.
10. Release the hooked tab that secures the CR LOCK KICKER and remove it
together with the CUTTER CAP, SOLENOID SPRING, and the SOLENOID
SHAFT. See Figure 4-71.
Disassembly & Assembly
See Figure 4-70.
See Figure 4-70.
See Figure
Tab and
Hooked
Tab
Notch
Disassembly Procedure
CUTTER SOLENOID
ASSY. harness
Retaining Clip
Hooked tab
IM Sensor Cover
Figure 4-70. Removing the CUTTER HOLDER
CR LOCK KICKER
SOLENOID
SHAFT
Hooked tab
Figure 4-71. Removing the CR LOCK KICKER
Revision B
C.C.P. 3x8
CUTTER HOLDER
Notch
CUTTER CAP
SOLENOID SPRING
249