Epson Stylus Pro 7400 Service Manual page 246

EPSON Stylus Pro 7400/7800/9400/9800
4.2.5.5 CR Encoder Sensor
1. Remove the H TOP COVER ASSY.
2. Unlock the CARRIAGE ASSY. and move the unit to the center.
page 215.
When performing the next step, be careful not to damage the
C A U T I O N
SCALE, CR.
3. Remove the screw that secures the CR ENCODER HOLDER and remove it.
One C.P.S.(S-P2) M3 x 8 screw
Set the two guide pins on the CR ENCODER HOLDER into
the positioning holes on the frame.
Guide Pins
Figure 4-64. Reinstalling the CR ENCODER HOLDER
After reinstalling the CR ENCODER HOLDER, make sure
that the SCALE, CR is properly inserted into the slit of the CR
Encoder Sensor.
Disassembly & Assembly
See Section 4.2.3.2 on page 221.
See Section on
See Figure 4-65.
SCALE, CR
Reassembly
Figure 4-65. Removing the CR ENCODER HOLDER
Disassembly Procedure
C.P.S.(S-P2) 3x8
CR ENCODER HOLDER
Revision B
246