Epson Stylus Pro 7400 Service Manual page 224

EPSON Stylus Pro 7400/7800/9400/9800
4.2.3.5 L SIDE COVER ASSY.
Ink may leak from the Cleaning Unit while or after removing the L
C A U T I O N
SIDE COVER ASSY. Have a waste cloth beforehand to wipe out
the leaked ink. When the L SIDE COVER ASSY. must be removed
for many hours, set the Maintenance Tank to collect ink leaked
from the Cleaning Unit.
The Stylus Pro 9400/9800 have two Maintenance Tanks, and the
C H E C K
P O I N T 7400/7800 have one tank on its right side.
1. Remove the Maintenance Tank.
2. Remove the Spindle. See Section 4.2.2.4 on page 219.
3. Remove the H Top Cover Assy.
4. Remove the I/H COVER L ASSY.
5. Remove the Side Cover Screw Cap.
Never forget to reattach the Side Cover Screw Cap, or the printer
C A U T I O N
may malfunction due to noise occurred in the internal electric
circuits. The caps are necessary to prevent the noise.
6. Remove the eight screws that secure the L SIDE COVER ASSY. and remove it.
Three C.B.P. M4 x 12 screws
One C.F.P. M4 x 12 screw
Four C.C.S. M4 x 8 screws
Make sure that there is no gap between the L SIDE COVER ASSY.
and the frame, then screw the L SIDE COVER ASSY.
Disassembly & Assembly
See Section 4.2.2.2 on page 217.
See Section 4.2.3.2 on page 221.
See Section on page 222.
L SIDE COVER ASSY.
C.C.S. 4x8
Figure 4-23. Removing the L SIDE COVER ASSY.
Disassembly Procedure
C.F.P. 4x12
6
5
Side Cover
Screw Cap
Revision B
C.B.P. 4x12
C.B.P. 4x12
224