HIKVISION DS-8004HCI-S User Manual page 93

alarm. A high sensitivity setting (like 5) will respond to smaller motions within images.
The default sensitivity is 2. You may have to test different sensitivity levels in order to
find the appropriate settings for some cameras.
4. Motion area setup: You must define motion areas so that DVR will response when there
is motion in those areas. Move the "Active Window" to the "Area" button on the right
side of sensitivity selection box and press [ENTER] to enter the "Motion Area Setup"
interface.
The screen is divided into 22*15 panes (22*15 PAL). There is one yellow panel on the upper left
side. The motion area setup steps are the same as that of mask area setup (refer to chapter 6.6).
The only differences are that you can use the [PTZ] key to set the whole screen as a motion area.
Multi motion areas can be defined.
5. Setup multi areas: After you setup one motion area, press the [EDIT] key.
The yellow pane will appear again allowing another motion box selection.
6. Clear part of motion area: Move the yellow pane near the start position of the area you
want to clear. Press [EDIT] and the yellow pane will turn black. Use the [↓] [→] keys to
enlarge or shrink the black area. Press the [EDIT] key to clear this part motion area.
7. Press [Enter] to save the changes, or [ESC] to cancel.
Note: Press [A] key to clear all motion areas.
The keys used to setup motion areas are as follows:
93