Setup at PC end
•
Setup the Modem used on PC side. Use a DCE cable to connect the Modem to the PC
serial port. You can use HyperTerminal or NetTerm to setup the modem:
AT&F ---- Restore default parameters (Generally, Modem is hard flow control)
AT&W&W1 ---- Save parameters
•
Open "Network and Dial-up Connections" in control panel, then press "New
Connection...", select "Dial-up to private network" according to the guide. Select the
corresponding modem. Input the telephone number to be dialed in the next step. Finish it
according to the instructions. At this time, you will find a new program named "Dial-up
Connection" in "Network and Dial-up Connections" folder.
Setup:
•
Open the properties of the newly established dialup program, select "Advanced" (custom
settings) in the security option, press setup. Setup the popup dialogue box (Advanced
Security Settings) as follows:
120