Leap Authentication Error Messages - Cisco Aironet Installation And Configuration Manual

Error Messages
Error Message You must specify an IP address before running a linktest!
Explanation
wireless device with which to test the RF link was not specified.
Recommended Action
of the access point or other wireless device with which you want to test the RF link.
Error Message You need to be an administrator or a user with administrative rights
to install Aironet Client Utility. Please log on as a different user and try again.
Explanation
terminates.
Recommended Action
Error Message Your Wireless LAN Adapter is not inserted!
Explanation
2) ACU was started with one variety of client adapter inserted (such as a PCM342), it was
subsequently ejected, and another variety was inserted (such as a PCM352).
Recommended Action
one is not present or 2) shut down ACU and restart it.

LEAP Authentication Error Messages

This section lists error messages that may occur during LEAP authentication.
Error Message Cannot find a wireless adapter that supports LEAP. Please make sure
that you have installed the correct client adapter and updated your firmware.
Explanation
LEAP.
Recommended Action
install the latest client adapter firmware.
Error Message Cannot find a wireless adapter that supports WEP. Please make sure that
you have installed the correct client adapter and purchased WEP support.
Explanation
Recommended Action
adapter for WEP support.
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
9-12
An attempt was made to run a link test although the IP address of the access point or other
In the Linktest screen's IP Address of Access Point field, enter the IP address
A non-administrative user attempted to install ACU. The ACU installation process
Logon as a different user and attempt the installation process again.
One of two conditions is present: 1) a client adapter is not inserted in your computer or
Perform one of the following: 1) insert a client adapter into your computer if
LEAP authentication failed because the client adapter's firmware does not support
Follow the instructions in the
LEAP authentication failed because the client adapter does not support WEP.
Make sure that you have installed the correct client adapter or upgrade the
Chapter 9
"Upgrading the Firmware" section on page 8-5
Troubleshooting
to
OL-1394-04