Cisco Aironet Installation And Configuration Manual page 79

Chapter 5 Configuring the Client Adapter
Table 5-3
Parameter
Transmit Power
OL-1394-04
RF Network Parameters (continued)
Description
Defines the power level at which your client adapter transmits. This
value must not be higher than that allowed by your country's regulatory
agency (FCC in the U.S., DOC in Canada, ETSI in Europe, MKK in
Japan, etc.).
Options: Dependent on the power table programmed into the client
Default: The maximum level programmed into the client adapter and
Possible Power Levels
30 mW or 1 mW
30 mW, 15 mW, 5 mW, or
1 mW
100 mW, 50 mW, 30 mW,
20 mW, 5 mW, or 1 mW
20 mW, 10 mW, or 5 mW
Note
Note
Note
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
adapter; see the table below
allowed by your country's regulatory agency
Client Adapter Type
340 series PC cards
340 series LM cards and PCI cards
350 series client adapters
PC-Cardbus card
Reducing the transmit power level conserves battery power but
decreases radio range.
When World Mode is enabled, the client adapter is limited to
the maximum transmit power level allowed by the country of
operation's regulatory agency.
If you are using an older version of a 340 or 350 series client
adapter, your power level options may be different than those
listed here.
Setting RF Network Parameters
5-11