Leap Authentication Error Messages - Cisco AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter Installation And Configuration Manual

Wireless lan client adapters for windows ce
Hide thumbs Also See for AIR-PCM352 - Aironet 350 Series 11Mbps Wireless LAN PC Card Adapter:
Table of Contents

Advertisement

Error Messages
Error Message No CE services are currently running on this computer. Please run
ActiveSync and make sure you are connected to a supported device. NOTE: This
Install is for 3.0 CE devices and greater.
Explanation
connection established between your laptop or PC and your Windows CE device.
Recommended Action
on page 3-2
Error Message Unable to load the Wireless Zero Configuration interface.
Explanation
Recommended Action
Error Message Windows CE Services not found on this computer. Setup cannot continue
and will now exit.
Explanation
This directory and the files it contains are needed to copy the client adapter's driver and client utility
files from the laptop or PC to a Windows CE device.
Recommended Action
install Windows CE Services on the laptop or PC and start the driver installation procedure again.

LEAP Authentication Error Messages

This section lists error messages that may occur during LEAP authentication.
Error Message Authentication attempt timed out. Rerun WLM and try again.
Explanation
Recommended Action
again.
Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
9-8
An attempt was made to install the client adapter installation file without an ActiveSync
Follow the instructions in the
to establish an ActiveSync connection.
An error occurred during installation, or the system is not working properly.
Reset the Windows CE device; then reinstall the client adapter software.
The driver installation utility cannot locate the ActiveSync directory on the laptop or PC.
Tap OK to acknowledge the message and terminate the installation utility. Then
Windows CE Services can be obtained from the CD that shipped with your Windows CE
Note
device or from the device manufacturer.
The client adapter was unable to authenticate within a specified amount of time.
Tap OK. Then open WLM, enter your LEAP credentials, and try to authenticate
Chapter 9
"Installing the Driver and Client Utilities" section
Troubleshooting
OL-1375-04

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aironet 350 series

Table of Contents