Cisco Aironet Installation And Configuration Manual page 193

Chapter 9 Troubleshooting
Error Message Software installed might not work properly if you choose not to restart
Windows. Please make sure to restart Windows before installing/using Aironet
Client Utility.
Explanation
screen during an uninstall or install of ACU.
Recommended Action
Error Message Unable to Open filename
Explanation
Recommended Action
try to load it again or select a different firmware file and try to load it.
Error Message Wireless Connection Unavailable. (Windows XP only)
Explanation
configure my wireless network settings check box in Windows XP is selected. This message appears
even if the client adapter is associated to an access point.
Recommended Action
box in Windows XP to force Windows to display the correct status.
Error Message You cannot run a linktest because the radio in your Wireless LAN
Adapter is not on!
Explanation
Recommended Action
drop-down menu; then run the link test.
Error Message You cannot run a linktest because your Cisco Wireless LAN Adapter is
not associated!
Explanation
access point or other wireless device.
Recommended Action
another wireless device.
OL-1394-04
The No, I will restart my computer later option was selected on the Setup Complete
Restart your computer before installing or using ACU again.
The selected firmware file cannot be found.
Re-copy the firmware file to a floppy disk or to your computer's hard drive and
ACU was used to configure the client adapter on Windows XP, but the Use Windows to
Deselect the Use Windows to configure my wireless network settings check
An attempt was made to run a link test while the client adapter's radio was off.
Turn on the client adapter's radio by selecting Radio On from the Commands
An attempt was made to run a link test while the client adapter was not associated to an
Run the link test after the client adapter is associated to an access point or
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
Error Messages
9-11