Using Static Wep; Entering A New Static Wep Key - Cisco Aironet Installation And Configuration Manual

Setting Network Security Parameters
Table 5-6
Security Feature
EAP-SIM authentication
MIC
TKIP
Broadcast key rotation

Using Static WEP

This section provides instructions for entering new static WEP keys or overwriting existing static WEP
keys.

Entering a New Static WEP Key

Follow the steps below to enter a new static WEP key for this profile.
Step 1 Select None from the Network Security Type drop-down box on the Network Security screen.
Step 2 Select Use Static WEP Keys under WEP.
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
5-28
Client and Access Point Security Settings (continued)
Client Setting
If using ACU to Enable Host Based EAP and Use
configure card Dynamic WEP Keys in ACU and
select Enable network access
control using IEEE 802.1X and
SIM Authentication as the EAP
Type in Windows 2000 (with
Service Pack 3 and the Windows
2000 Wireless 802.1X hot fix) or
Windows XP
If using Windows XP Select Enable network access
to configure card control using IEEE 802.1X and
SIM Authentication as the EAP
Type
Use PCM/LMC/PCI card driver
version 8.01 or greater, mini PCI
card driver version 2.20 or greater,
or PC-Cardbus card driver version
3.4 or greater
Use PCM/LMC/PCI card firmware
version 4.25.23 or greater, mini
PCI card firmware version 5.0 or
greater, or PC-Cardbus card
firmware version 4.99 or greater
Use PCM/LMC/PCI card firmware
version 4.25.23 or greater, mini
PCI card firmware version 5.0 or
greater, or PC-Cardbus card
firmware version 4.99 or greater
and enable LEAP
Chapter 5 Configuring the Client Adapter
Access Point Setting
Set up and enable WEP with full
encryption and enable
Network-EAP
Set up and enable WEP with full
encryption and enable Require
EAP and Open Authentication
Set up and enable WEP with full
encryption, set MIC to MMH, and
set Use Aironet Extensions to Yes
Set up and enable WEP, set TKIP to
Cisco, and set Use Aironet
Extensions to Yes
Set up and enable WEP and set
Broadcast WEP Key Rotation
Interval to any value other than
zero (0)
OL-1394-04