Cisco Aironet Installation And Configuration Manual page 103

Chapter 5 Configuring the Client Adapter
Step 2 Perform one of the following:
• If you are planning to use EAP-TLS, PEAP, or EAP-SIM authentication, select Use Dynamic WEP
Keys under WEP.
• If you are planning to use EAP-MD5 authentication with static WEP, select Use Static WEP Keys
under WEP. Then follow
create a new static WEP key or follow the steps in the
section to overwrite an existing static WEP key.
If you are planning to use EAP-MD5 authentication without WEP, select No WEP under WEP.
•
Click OK to return to the Profile Manager screen.
Step 3
Step 4 Click OK or Apply on the Profile Manager screen to save your changes.
Step 5 Perform one of the following, depending on your computer's operating system:
• If your computer is running Windows 2000 (with Service Pack 3 and the Windows 2000 Wireless
802.1X hot fix), double-click My Computer, Control Panel, and Network and Dial-up
Connections. Right-click Local Area Connection. Click Properties. The Local Area Connection
Properties screen appears.
• If your computer is running Windows XP, double-click My Computer, Control Panel, and
Network Connections. Right-click Wireless Network Connection. Click Properties. The
Wireless Network Connection Properties screen appears.
Note
Click the Authentication tab. The following screen appears (see
Step 6
Note
OL-1394-04
Step 3
These instructions assume you are using Windows XP's classic view rather than its category
view.
When Service Pack 1 for Windows XP is released, the Authentication tab may move from its
current location. To access it, click the Wireless Networks tab, select the network that you are
configuring in the Preferred network list, and click Properties.
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
through Step 7 in the "Entering a New Static WEP Key"
"Overwriting an Existing Static WEP Key"
Setting Network Security Parameters
Figure 5-7).
section to
5-35