Connecting The Rmx 4000 To The Power Sources - Polycom RMX 2000 Getting Started Manual

Connecting the RMX 4000 to the Power Sources

The size of the protective earthing conductor & cable should be a minimum of
10AWG.
Connect the following power cables to the RMX 4000 back panel:
AC Power Supply connections:
1
Insert power cables to each of the three AC Power Entry Modules
(PEM's).
Figure 2-1 RMX 4000 Rear Panel View with AC Power
DC Power Supply connections:
1 On the DC Power Entry Modules (PEM's), set the two circuit breakers
to OFF.
2
Ensure that the cables from the Main that supplies electricity to the
DC power units are OFF or disconnected.
3
Remove the transparent plastic caps on the terminal block.
Polycom RMX 2000/4000 Getting Started Guide
Power Cables
2-11