D-Link xStack Reference Manual page 866

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
ipif - (Optional) Specifies the OSPFv3 IP interface name used.
<ipif_name 12> - Enter the OSPFv3 IP interface name used here. This name can be up to 12
characters long.
all - (Optional) Specifies that all the OSPFv3 IP interfaces will be used.
Restrictions
None. (EI Mode Only Command)
Example
To display OSPFv3 configurations or interfaces information:
DGS-3620-28SC:admin# show ospfv3
Command: show ospfv3
OSPFv3 Router ID: 1.1.1.1
State : Enabled
OSPFv3 Interface Settings
Interface Area ID
------------ --------------- -------- --------- --------- -----------
System 0.0.0.0
Total Entries: 1
OSPFv3 Area Settings
Area ID Type
--------------- ------ ----------------------- -----------------
0.0.0.0 Normal None
Total Entries: 1
Virtual Interface Configuration
Transit Virtual
Area ID Neighbor Router Interval Interval
--------------- --------------- -------- -------- ----------- ------
Total Entries: 0
OSPFv3 Area Aggregation Settings
Area ID Aggregated
Network Address
--------------- ------------------------------------------- -------- ---------
State Link
Status
Disabled Link Up
Stub Import Summary LSA Stub Default Cost
Hello Dead
861
Metric Instance ID
10 0
None
Instance ID Link
Status
LSDB
Type
Advertise