D-Link xStack Reference Manual page 1231

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
show wac auth_state ports {<portlist>}
Parameters
<portlist> - (Optional) Specify the list of ports whose WAC authentication state will be displayed.
Restrictions
None.
Example
To display the WAC authentication status of ports:
DGS-3620-28SC:admin# show wac auth_state ports
Command: show wac auth_state ports
P:Port-based Pri:Priority
Port MAC Address
------ -------------------- ---- -------------- ---- -- ----------- ----
31 00-05-5D-F9-16-76
Total Authenticating Hosts
Total Authenticated Hosts
Total Blocked Hosts
DGS-3620-28SC:admin#
115-17 clear wac auth_state
Description
This command is used to clear the authentication state of a port. The port will return to un-
authenticated state. All the timers associated with the port will be reset.
Format
clear wac auth_state [ports [<portlist> | all] {authenticated | authenticating | blocked} |
macaddr <macaddr>]
Parameters
ports - Specifies the list of ports whose WAC state will be cleared.
<portlist> - Enter a range of ports.
all - Specifies to clear all ports.
authenticated - (Optional) Specify to clear all authenticated users for a port.
authenticating - (Optional) Specify to clear all authenticating users for a port.
blocked - (Optional) Specify to clear all blocked users for a port.
macaddr - Specifies to clear a specific user.
Original State
RX VID
1 Authenticating -
: 1
: 0
: 0
1226
VID Pri Aging Time/ Idle
Block Time
- 27
Time
-