D-Link xStack Reference Manual page 991

Dgs-3620 series layer 3 managed stackable gigabit switch

Hide thumbs Also See for xStack:

Table of Contents

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

85-11 config 802.1p default_priority

This command is used to specify default priority for untagged packets received on a port of the

config 802.1p default_priority [<portlist> | all ] <priority 0-7>

<portlist> - Enter a range of ports for which the default priority is to be configured. That is, a

range of ports for which all untagged packets received will be assigned the priority specified

below. The beginning and end of the port list range are separated by a dash.

all - Specifies that the command applies to all ports on the switch.

<priority 0-7> - Enter a priority value (0 to 7) to assign to untagged packets received by the

switch or a range of ports on the switch.

Restrictions

Only Administrator, Operator and Power-User level users can issue this command.

To configure an 802.1p default priority settings of 5 on all Switch ports:

DGS-3620-28SC:admin#config 802.1p default_priority all 5

Command: config 802.1p default_priority all 5

DGS-3620-28SC:admin#

85-12 show 802.1p default_priority

This command is used to display the current default priority settings on the switch. The default

priority can also be assigned by the RADIUS server through the authentication process.

Authentication with the RADIUS server can be either per port or per user. For per port

authentication, the priority assigned by the RADIUS server will be the default priority of the

effective port. For per user authentication, the priority assigned by RADIUS will not be the effective

port default priority, as the will priority associated with MAC address will be assigned. Note that

only devices supporting MAC-based VLANs can provide per user authentication.

show 802.1p default_priority {<portlist>}

Chapters

Table of Contents

Xstack dgs-3620-28sc