D-Link xStack Reference Manual page 1180

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config tftp source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
<ipaddr> - Enter the IPv4 address used here.
<ipv6addr> - Enter the IPv6 address used here.
none - Specifies to remove the specified source address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the IP 10.90.90.90 on System interface as the source address:
DGS-3620-28SC:admin#config tftp source_ipif System 10.90.90.90
Command: config tftp source_ipif System 10.90.90.90
Success.
DGS-3620-28SC:admin#
110-27 show tftp source_ipif
Description
This command is used to show the configured source address for TFTP.
Format
show tftp source_ipif
Parameters
None.
Restrictions
None.
Example
To display the source address for TFTP:
DGS-3620-28SC:admin#show tftp source_ipif
Command: show tftp source_ipif
Telnet Source IP Interface Configuration:
1175